2018 Fuji sFAB-D Multi-purpose Automated Fabrication Machine (Odd Form Placer)
SKU:
$1.00
$1.00
per item
2018 Fuji sFAB-D Odd Form Placer
ONLY 930.00 Hours.
IN LIKE NEW CONDITION
Daily Maintenance performed while under operation
Applicable head(s): sH02 head
Clamp width: 0.5 to 47mm
Supply Voltage: AC 200-230V
Full Load Amp: 50A
Freq: 50/60Hz
Phase: 3
Serial#: 000037
December 2017 MFR Date
Part height: 65mm or less (including leads)
Kit types5 types:
- Starter tool kit for light parts
- Starter tool kit for small parts
- Full set for light parts
- Full set for small parts
- Full set for large parts
OVER $250,000 MSRP
1 available
Parts that can be mounted/assembledAxial and radial leaded parts, DIP parts*1, odd-form parts*2
PCB size (W x L)48×48mm～435×500mm（single conveyor）
48×48mm～410×340mm（with cut and clinch unit）
Panel thickness0.4～2.0mm
Part typesAxial leaded parts
(under development)Insertion pitch: Changeable (up to 15mm)
Part packaging: Ammo pack, reel (tape width: 52mm)
Radial leaded partsInsertion pitch:2.5/2.5×2/5mm Lead diameter: 0.4 to 0.6mm *3
Part packaging: Ammo pack, reel（tape width: 18mm Tape indexing pitch: 12.7 / 15mm）
DIP / odd-form partsMaximum part size：160 x 160 mm or 226.3 mm diagonal (when using sH02 head)
Parts supply : Stick, tray, tape
Part insertion angleAny can be supported (specified in increments of 0.001 degrees)
OptionsPins / leads check
Part presence check
Part insertion check
Insertion placement
Conveyor with cut and clinch function
Backup pins
Reject parts conveyor
Production information viewer
Simple verification
PCB size (W x L)48×48mm～435×500mm（single conveyor）
48×48mm～410×340mm（with cut and clinch unit）
Panel thickness0.4～2.0mm
Part typesAxial leaded parts
(under development)Insertion pitch: Changeable (up to 15mm)
Part packaging: Ammo pack, reel (tape width: 52mm)
Radial leaded partsInsertion pitch:2.5/2.5×2/5mm Lead diameter: 0.4 to 0.6mm *3
Part packaging: Ammo pack, reel（tape width: 18mm Tape indexing pitch: 12.7 / 15mm）
DIP / odd-form partsMaximum part size：160 x 160 mm or 226.3 mm diagonal (when using sH02 head)
Parts supply : Stick, tray, tape
Part insertion angleAny can be supported (specified in increments of 0.001 degrees)
OptionsPins / leads check
Part presence check
Part insertion check
Insertion placement
Conveyor with cut and clinch function
Backup pins
Reject parts conveyor
Production information viewer
Simple verification